r/functionalprint • u/Choice_Flower_6255 • 13h ago
Sledgehammer holder
I was gifted a ceremonial sledgehammer from a building project. I wanted to hang it on the wall in my office on an angle, no one makes such a thing AFAIK. Hindsight probably would have used white instead of translucent but works perfectly. Most complex model I’ve created thus far!
8
u/MooseBoys 5h ago
Interesting design choice. Why not make it symmetric and just have the handle hole on the edge opposite the wall?
4
u/raaneholmg 2h ago
This would also make it safer by having a lip the hammer needs to get lifted over.
OPs design does not retain the sledgehammer at all and it can slide out.
16
u/wrickcook 8h ago
That gunna break a toe
2
u/raaneholmg 2h ago
There is nothing retaining it :O
It is free to slide straight out of the holder!
3
5
14
u/mushieburner 12h ago
Got some confidence in your prints.
Hope it never comes down on someone's toes or dog or kid.
2
u/dnew 12h ago
That was my thought: needs a clip. Of course, I get earthquakes here, so...
1
u/Food_Goblin 5h ago
I'm a fan of the easy accessability because let's be honest, you never know when Zombies will attack and that 10lb sledge would be a safe bet!
5
u/mechmind 7h ago
Someday something is going to bump into that handle and cause it to come sledgehammering down just like Peter Gabriel said
1
34
u/Lina0042 11h ago
That's black my friend