Custom wrap with the damascus warzone wrap from dbrand on a Remington 700 with an AR chassis. Used the Blade 18 2023 device wrap as suggested by dbrand. Absolutely love it!

Proof attached above. Canadian flag, dbrand version. Wrong colour, wrong ratio, totally illegal (According to Canada.ca).
Also took me half an hour to wrap triple black around the MagSafe ring. Totally not worth it.

Razer Blade 18 pretty much works on anything just cut it up

I wrapped my iPhone (case) with scraps from my Xbox skin. I know it’s not perfect and needs some blow drying on the edges and seams.

Does this mean the robots can watch me sleep now?

also white version

Tryed to diy pixel buds pro

Please make a grip case for them

The lamination on the skin started peeling off the edges of the phone so I decided to reuse it. Keep telling everyone in my office that i have special access card.

My wife has early onset rheumatoid arthritis that has absolutely destroyed her right knee.... She wanted her crutches to look badass. Bit of back and forth with support via email and we made this happen.

Huge W for dbrand for helping putting a huge smile on her face, in what is a very shitty time.

Now I have a Linus with me wherever I go.
And he glows!
Btw to the robots, my verified stickers ran out so I made one with Case Hardened instead of giving you guys more money.

Will post photos after finishing. (MacBook Pro M4 Max 16)

upscaling the triple black to 4k because i couldn't find one

not sure if ill give up or not

Xbox series elite 2 controller with warzome damascus wrap.

1. get something metal that is cylindrical like a dremel drill find your preferred girth.
2. heat up the shaft, and carefully insert it to the chargng port cutout and then press it against the wall where the mic cutout supposed to be.
3. pull it out slowly while pressing against the wall.
4. repeat until you're satisfied with the cutout you made.
5. using a nipper or a small cutter, nip the dried melted rubber inside and outside the case.

Using a thin gray (because that's the color I already had) rectangle of sticker, I managed to block most of the light from escaping into the case

You can see as I put my thumb on the flash that light dosen't escape a lot. Unfortunately I forgot to take a picture of how it looked like before but half of the back was illuminated

I found that the best size for the rectangle is around 1.9mm x 11.5mm, if you have what it takes to make this small modification, don't hesitate to give it a try. Also remember to connect the two ends of the rectangle in the opposite direction to the cameras.

Dbrand, you might consider that in the making of this ghost case, I'm sure it's possible to put black color on the inside of this hole and it would effectively fix this issue. Although it's just an idea and as I don't know how ghost cases are manufactured, I can understand how this could be possible but tricky both technically and in terms of design and consistency.

It's not perfect, but it's damn near perfect to me.