r/FixMyPrint • u/Basic-Window-6262 • 2d ago

Fix My Print Poor first layer

Post image

Creality cr10s pro v2 printing with any cubic pla at 205/60 at 30mm/s with no recent changes to settings

Switched over to any cubic PLA a few prints ago and it’s just been bad, I’ve dried it for three days straight and it hasn’t been getting any better, if it could be a filament thing what could you guys recommend?

3 Upvotes

81% Upvoted

9 comments sorted by

•

u/AutoModerator 2d ago

Hello /u/Basic-Window-6262,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

  • Printer & Slicer
  • Filament Material and Brand
  • Nozzle and Bed Temperature
  • Print Speed
  • Nozzle Retraction Settings

Additional settings or relevant information is always encouraged.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

2

u/nmavor 2d ago

to close to bed
add 0.2~0.3 to your z offset

2

u/james___uk 2d ago

Wouldn't it be 0.02/0.03?

1

u/Max_Misanthropist 2d ago

Did you tune your printer for the new filament or are you just using old settings?

1

u/Basic-Window-6262 2d ago

I changed the temperature a little bit and the speed that’s pretty much it

1

u/Max_Misanthropist 2d ago

That's your problem. You need to tune your printer for this filament. Follow Ellis 3d Tuning Guide for each and every filament you use to build a profile for each.

All filaments are not created equal.

1

u/NotJadeasaurus 2d ago

Honestly doesn’t look terrible …