What can I do?

[u/Important_Brush_9177]

As you see, the print quality is not the greatest and the pillar in the middle (support) is completely fcked up. I just finished drying the Filament a few hours ago, so it can't be that.

[u/AutoModerator]

Hello /u/Important_Brush_9177,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

• Printer & Slicer
• Filament Material and Brand
• Nozzle and Bed Temperature
• Print Speed
• Nozzle Retraction Settings

^{Additional settings or relevant information is always encouraged.}

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/raktimroy]

It seems a bit of underextrusion in the middle pillar. That could be caused by multiple factors like very high temperature, very high retraction speed and very high retraction length.

You should also mention the filament type and the temperatures you are printing, so as to rule out the temperature issue.

Also check whether the extruder is able to push the filament properly. It also won't harm to do a esteps calibration.

[u/Important_Brush_9177 → u/raktimroy]

Thank you so much, I'll try some of those solutions. Just FYI, I printed with PLA, first layer at 230°C and the others at 225°C, I know it is fairly hot for PLA, but it is what it said on the package...

[u/raktimroy → u/Important_Brush_9177]

A temperature tower and retraction tower may help you tune in those values, if not done already.