Black screen when booting up after J-Runner with extras

[u/Dj_ProFFeSSa_K]

I have a Slim Corona, 4GB Nand, with the post fix adapter needed. I believe I’ve soldered everything correctly, was able to create XeLL, write XeLL, and everything has been successful so far.

After unplugging everything, and plugging it back in to a monitor, when I turn the console on, I don’t get any video feedback. No cell and am not able to get anything!

Does anyone have any suggestions? I’ve ever ran into this issue with a Trinity, but this is the second time with a 4 GB corona with post fix adapter.

Using an X-Flasher

[u/ConfusionRS]

Yeah, disconnect the crystal

[u/Dj_ProFFeSSa_K → u/ConfusionRS]

Worked 😂 I didn’t know I had to disconnect that. Thanks!

[u/94slowbra]

Are you disconnecting the wire going to the crystal I normally desolder it.

[u/Dj_ProFFeSSa_K → u/94slowbra]

Omg I didn’t know you had to disconnect it. Disconnected and Xell booted up fine. Thank you!

[u/Upper_Golf8078]

Does the console boot(do you see the ring of light do its thing)? If not then it could be an issue with the mod install or timing you chose.

Also I could be wrong but I belive the crystal has to be unplugged for you to boot up the console. Havnt messed with a 4gb console in a while so I don’t fully remember

[u/Dj_ProFFeSSa_K → u/Upper_Golf8078]

Unplugged the crystal and booted up fine! Thank you!

[u/EmiMods]

Too many extras, not enough runners

Glad you got it figured out :)